Class 40 Verdier Tyker 3 For Sale A Vendre





#121 has had 2 x owners from new. Built and owned by a US based sailor this yacht has the finest pedigree. Under previous ownership #121 only sailed one Trans-Atlantic delivery and an East Coast US race. OC Performance Brokerage sold the boat to her current Sydney based owner. Unfortunately the boat is now reluctantly for sale again, extremely low mileage and in very good condition indeed. From the outset of build and design this boat had probably the finest input from some of the biggest talents in offshore racing. Roland Jourdain ‘Bilou’ was the commissioning owners’ rep’ during the yard construction phase and as a result numerous fundamental decisions to evolve and improve this boat were implemented. This included and not limited to: Ballast system improvement and optimisation, refined weight distribution, deck layout optimisation, refined rig design. Electrical installation were carried out by Pixel sur Mer and Bilous’ own team.
Under the current owner the boat was shipped from the USA and completely overhauled and refitted including, new wardrobe of North Sails, all the running rigging and  fibre stays replaced, much of the electronics either upgraded or replaced. New safety gear. Vinyl wrap added over the bare white hull and decks for hull graphics.
An immaculate “Turn-Key” yacht, ready to race! The present owner left nothing to chance in preparation for the 2018 Melbourne to Osaka two-handed yacht race and as such, Nexba presents like new and has the latest and best equipment for ocean racing, single/double handed or fully crewed!
 
Built mid 2012 FR Nautisme, Lorient, France
Vacuum bagged E-glass - foam - epoxy
Architect: Verdier
CE certification: Category A
Conformity: Class40 
LOA: 12.19 m
Beam: 4.5m
Draft: 3.00 m
Displacement: 4500 kg
Fuel Capacity: 84L
Water Capacity: 50L fixed tanks plus 2 x 100L bladders
Keel Type: Fin and lead bulb
Water Ballast: 3 x tanks per side (total of 750 litres per side)
Engine: Volvo D1 30hp
Propellers:  1 x folding 2 blades
Drive Type:  shaft- composite fairing around shaft outside hull
Steering system: Twin kick-up rudders and central tiller
 
Accommodation:
Toilet: Carbon fibre manual flush toilet mounted forward in cabin
Galley located in saloon: forward of nav’ station. Sink with hand pump for fresh/ salt water, Jet boil gas burner, storage
Navigation Station: central amidships aft of galley
Bunks: 2 x pipe cots alongside nav’ Station
Layout: Two-sided companionway with watertight doors lead to central cabin with Navigation station and bunks outboard.
Storage: 2 x Fabric Crew gear lockers

Sails:
All new sail inventory from North Sails Sydney for Melbourne to Osaka Race 2018, designed by North Class 40 guru Juan Meseguer.
3Di endurance 760 3 reef offshore mainsail
3Di endurance 760 furling headsail (on forestay)
3Di endurance 760 furling staysail (on removable inner forestay)
3Di carbon RAW code zero (on Future Fibres torsion cable)
A2 Masthead running spinnaker in snuffer. Superlite SK130 White
A3 Masthead reaching spinnaker- furling on cable. Maxi-kote MK200P
A6 Fractional running spinnaker in snuffer. Superlite SK250
Spinnaker Staysail (Drifter)
 
Other Sails from North Sails France in good condition and lightly used.
Mainsail 3Di 2012    
Solent 3Di 2012    
Staysail Norlam 2012     
Storm jib Dacron 2012     
Code 0 Pentex 2012     
A2 Superkote 2014    
A3 Superkote 2012    
A6 Superkote 2014
Storm Jib
Delivery jib
Winches: 6 x Harken Performa Racing STRs
Deck hardware: Harken and Spinlock. Upgrades throughout for Melbourne to Osaka Yacht Race 2018
 
Rig/Mast:
Deck stepped Axxon Carbon Two Spreader mast and boom.
Nitronic rod side rigging, Future Fibres PBO forestay and backstays/ check stays
Lazy jacks and boom bag, Headstay and staysail stay furling
All running rigging, forestay and backstays replaced 2018
Clear carbon finish on rig and boom
Carbon reaching strut with “quick plug in” mounts on mast
Bowsprit:  Rotating bowsprit with locking pin
Furlers:  All furling gear is by Karver plus spares
 
Electrical:
Radios:  VHF- Icom DSC enabled permanently installed
VHF- Icom HH VHF radio and charger permanently mounted
HF- Icom HF radio (removed but cabling, aerial mount and face plate/ handset still installed)
B&G H3000 Instruments with 4 x cockpit displays and 1 x nav station display
Simrad NSS7 chart plotter
2 x MHU mounted on mast (upper and lower)
Echomax active echo
Simrad Radar
Bohiken marine barograph
2 x Independent Pilots
KVH Gyro-pilot compass, B&G computers x 2, driving 2 x Raymarine linear drives
Fleet Broadband 150 satcom and phone, 4G mobile internet modem, Class B AIS, on board wifi.
Permanently mounted ships computer, flat screen, keyboard and mouse. All navigation and communication software. (Option to purchase X-plore Tablet computer with wired charging cradle)
Batteries: 2 x house batteries and engine start battery. Details TBC
Spectra Power Survivor 40E Water maker
2 x Solbian SP78 solar panels mounted on cabin top           
2 x Solbian SP52L solar panels mounted on cabin top
2 x Watt and Sea hydro-generators, mounts on transom and all converters etc
Electrical Equipment Notes:
All electrical equipment updated or replaced 2017-2018 for Melbourne to Osaka Race
(New B&G processor, new Fleet broadband, re-wired by Olectric Systems)
2 x sets of LED Navigation lights (masthead and on stern rails)
Spare keyboard and Mouse
Spare LED 12V computer monitor
Battery monitor mounted on nav table
Various USB charging hubs located in nav station and above bunks
Battery operated remote cooling fans
 
Safety Equipment:
Full Cat 1 “plus” for Melbourne to Osaka (additional medic kit, etc).
Liferaft storage in transom via watertight door.
Safety Notes: Safety equipment all supplied and managed by Marine Safety Works- Sydney. Watertight bulkheads forward and aft, plus additional Class 40 foam floatation
 
Miscellaneous Equipment/ Spares:
Rigging- various items (sheets/ runner tails etc) plus spare backstays/ check stays/ forestay
Lightweight fabric sun awning for dock or whilst sailing in light winds
Mooring lines / fenders
Anchor:  2 x Fortress alloy anchors with regulation chain and warp for Cat 1
General plumbing/ electrical/ rigging spares
Extensive sail repair kit
Covers
Deck hardware spares
 
Available for viewing in Australia.
Viewing will not disappoint. Assistance can be given in shipping to Europe or the US
SOLD
For further high resolution photographs and to register an interest please contact: Brokerage
Inventory to be confirmed and subject to contract:
 

Top of Page

[ Back ]
Privacy Policy | Web Design By Toolkit Websites